Board for Sale- 5-9 Windigo Bonzer Surfboard by Barry Snyder – $375

I’m probably going to regret doing this but up for sale is a 5-9 x 19.5 x 2.38 Windigo J-Rob model with a Bonzer 5 fin setup. I really want to keep it but I have gone off the rails on my Minimalist Quiver idea and the boards are starting to overflow the racks. Also, I somehow have gotten wild about thrusters, something that I have never been into before.

Most Bonzers are glass-on, but this one was built with a FCS setup for easy traveling.

It has only been ridden 5 times, and is basically pristine besides wax. Barry Snyder is a master shaper that does everything by himself, by hand. I just have too much overlap in this segment of my quiver so it has to go. This board will be the fastest board you own.

Asking $375 which is a steal. Board was $450, Bonzer center fin was $50, and the FCS Bonzer side fins were $100 for a total of 6 bills.

Buy it before I change my mind!

Here’s what Barry has to say about this surfboard

Wide Point Forward (WPF)
Wide point is up 3 1/2″. Super curvy.
This board is a throw back to the time when
front footed surfing was in. Steering with your front foot
and getting barreled deep.
The WPF is the most versatile board in the range. It has a high amount of volume under the chest which enables it to paddle like a dream. The way you surf the WPF is on the open face, where you draw fast flowing lines.

The outline resembles an old school twin fin in the nose, yet it draws back to a tight rounded pin tail. The wider straighter outline up front will give you plenty of speed, yet the round pin tail allows you to turn tight in the pocket.

The rocker is flat throughout, although there is a little extra lift in the entry, which helps when taking off late or turning in the steeper sections of the wave. The design of the rocker is focused around speed! You will find you will make sections that you never expect to make.

The foil has plenty of volume around the chest and center area of the board, yet it refines out to a thinner, pinched rail to keep the board connected to the wave.The concave runs from a rolled vee in the entry to a slight single blending into a vee double out the tail which gives the board great speed and control from rail to rail.

You will enjoy riding it from small average conditions to clean long barreling point breaks.

Bonzer- The Bonzer is a 3- or 5- array invented by the Campbell brothers in Oxnard, California in the early 1970s for the powerful waves of a well-known wave near their home. The Bonzer array is an approximately 7″ center fin aft and either two or four delta-shaped fins (“runners”) mounted near the rails in somewhat similar fashion to other rail fins, but they are substantially lower aspect and aggressively canted outward. The Bonzer array is firmly held to be an integral part of the Campbell brothers’ overall board design featuring double concave bottom contours out the tail.

Combined with the outline is modern bottom contours and rails.

Advertisements

4 thoughts on “Board for Sale- 5-9 Windigo Bonzer Surfboard by Barry Snyder – $375

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s